Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Diamondhead, MS

Haas Door Garage Door Roller Replacement in Diamondhead, MS

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. Typical cost $150-$350.

Garage doors rarely fail at a convenient time. If you need Haas Door garage door roller replacement in Diamondhead, MS, we can often come out the same day when a technician is available. Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. Whether your Haas Door garage door is a few years old or a few decades, we can diagnose it and tell you honestly whether it is worth repairing. Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

When to call for Haas Door garage door roller replacement

  • Grinding, squealing or rumbling as the door moves
  • The door shakes or jerks in the track
  • Cracked, chipped or wobbly rollers
  • Rollers that no longer spin freely

Common causes

  • Worn-out bearings in steel rollers
  • Cracked builder-grade plastic rollers
  • Rust or dust packed into the bearings

Before the technician arrives

  • Watch the rollers while the door moves. They should roll, not slide.
  • Look for cracked plastic wheels or wobbling stems.
  • Leave the bottom rollers to a technician. They sit in brackets that hold cable tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Inspect every roller, hinge and track section
  2. Replace rollers one hinge at a time, with sealed nylon rollers for a quieter door
  3. Replace the bottom rollers safely with tension controlled
  4. Lubricate hinges and bearings
  5. Test for smooth, quiet travel

Haas Door Garage Door Roller Replacement cost in Diamondhead, MS

$150-$350Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Haas Door services

Serving Diamondhead, MS and nearby towns

Humid air in Mississippi rusts cables, roller bearings and hinges, which makes the door noisy and heavy and eventually makes the opener strain.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Our Haas Door garage door roller replacement service covers Diamondhead (ZIP code 39525) and nearby towns including Kiln (4.4 mi), Bay Saint Louis (6.3 mi), Waveland (7.5 mi) and Pass Christian (8.8 mi). Call (833) 435-8883 to book a visit in Diamondhead.

Haas Door Garage Door Roller Replacement: frequently asked questions

How much does Haas Door garage door roller replacement cost in Diamondhead, MS?

Haas Door Garage Door Roller Replacement typically costs $150-$350 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Haas Door garage door roller replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Haas Door garage door roller replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Haas Door warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Mississippi or Diamondhead requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Diamondhead, MS

Genie Garage Door Opener Repair

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $125-$350

Insulated Garage Door Installation

Polystyrene and polyurethane insulated doors that cut noise and temperature swings.

Typical $1,500-$5,000

Northwest Door Off-Track Garage Door Repair

Doors that have come off their tracks secured, re-hung and realigned.

Typical $175-$450

Overhead Door Opener Circuit Board Replacement

Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Typical $175-$400

Marantec Remote & Keypad Programming

Marantec is a German manufacturer of residential and commercial door openers.

Typical $50-$150

Rolling Fire Door Inspection & Drop Testing

Annual drop testing and inspection of rolling fire doors.

Typical $150-$500

Allstar Garage Door Opener Repair

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $125-$350

Allstar Remote & Keypad Programming

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $50-$150

Wayne Dalton Garage Door Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$450

Midland Garage Door Garage Door Repair

Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close.

Typical $150-$450

Marantec Garage Door Opener Repair

Marantec is a German manufacturer of residential and commercial door openers.

Typical $125-$350

Allstar Opener Circuit Board Replacement

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $175-$400

Garage door stuck, noisy or broken?

Talk to a garage door technician in Diamondhead, MS now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote